![]() When the yellow colour comes, release the button that you were holding till now.Now, the strip will turn on and change all the colours one by one.The LED light will take a moment to turn on.Again, press and hold the power button.Hold the power button pressing it for a couple of seconds.Take the power adapter keeping the remote control on.At first, plug the LED strips and then turn the lights on.It is an effective fix for every LED strip problem. When you do not get any loose connections or power supply issues, you can reset the LED. You can split the solder using a knife not to touch the power supply’s positive and negative ends.If you find any solder to go across the connections, you have to resolder it. At first, thoroughly check each of the single strip parts closely.It will burn the strip and cause a fire hazard. When there is a touch between positive and negative connections in the power supply, it creates a short circuit.Ī short circuit can fail the LED strip within a couple of hours. If it does not work after doing this, check the cable from the solder pad on the strip.If you don't have a light tester, you can check each bulb on the string for tightness and look for visual clues, like cloudy or dark. Suggested Fix: Use a light tester to identify and replace loose or burnt out bulbs. Then connect the negative power supply to the colour strip that is not working. How to Fix Christmas Lights: Replace Fuses. Connect the black cable of the RGB/RGBW strips to the positive power supply. Then directly connect the strip and the controller directly to the power source. If you have extended the connection by a connector block, remove this connection.At first, check the cables that connect the strip with the controller.You can get only the section of the strip and solder it using the connector clips.Īnother problem is that half of the LED strip light not working for one colour, sometimes. If this solution does not work, you have to change the strip. The lights come back in the right colours. Sometimes, it works miraculously only when the problem is with the dry solder joints. How to work LED lights colours?įirst, touch and press on the LED strip where the colour of the light is wrong. ![]() This problem can occur when the strip is bent too much, static electricity damage, dry solder joints, or cheap quality strip or damaged transit. If the strand flickers, there is a loose connection, and you have to change the link.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |